Outboard Motor Brackets - Sea-Dog

Provider of high quality marine and industrial hardware

Sea-Dog Motor Brackets - strong, lightweight marine grade aluminum for small sailboat with auxiliary power.

Outboard Motor Brackets - Transom and Horizontal Mount Fixed Motor Brackets.

Contacts:

Sea-Dog Line Corporation
P.O. Box 479
Everett, WA 98206 USA

Web: www.sea-dog.com

Outboard Motor Brackets

Transom / ALUMINUM / Mount Fixed Motor Bracket - Model 371500

Stamped Aluminum/Injection Molded Polypropylene

Designed to attach directly to a vertical transom. Made of strong, lightweight marine grade aluminum, powder coated in white for maximum corrosion resistance. Reinforced polypropylene mounting board is 1-1/2" thick with all stainless steel fasteners.

Does not include mounting fasteners. The use of a safety chain or cable is recommended on all motor brackets . Also see Rail Mount Motor Bracket in section six under part numbers 327150 , 327151 .

Horizontal ALUMINUM SWIMSTEP Mount Fixed Motor Bracket - Model 371580

Stamped Aluminum/Injection Molded Polypropylene

Designed to attach directly to a horizontal swim platform. Made of strong, lightweight marine grade aluminum, powder coated in white for maximum corrosion resistance with a sturdy polypropylene mounting board.

The bracket will hold up to a 10 hp (2 cycle) outboard motor. Reinforced polypropylene mounting board is 1-1/2" thick with all stainless steel fasteners. Does not include mounting fasteners. The use of a safety chain or cable is recommended on all motor brackets . Also see Rail Mount Motor Bracket in section six under part numbers 327150 , 327151 .

Motor Brackets Installation Instructions :

-Attach motor bracket board to aluminum side plates with enclosed fasteners as shown in illustration.

-Place assembled unit in desired location on the swim platform. Make sure that auxiliary motor will be at the height recommended by the manufacturer and that it will not be obstructed by the main motor or rudder.

-Make sure the desired location of the bracket and auxiliary motor will not interfere with the free movement of the main motor or rudder through its entire swing.

-After finding a clear location on the swim platform for the bracket, mark the four mounting holes on the swim platform by using the bracket as a template. Drill 11/32" holes perpendicular to the swim platform and use installer supplied 5/16" diameter stainless steel carriage bolts with flat washers and nylon insert lock nuts on the underside of the swim platform. Swim platform may have to be reinforced.

-Apply a marine sealant on the mounting bracket surfaces which contact the swim platform and in the bolt holes through the swim platform and tighten the nuts securely.

-Rated for 2 stroke motors only to 10 H.P. Always use a safety chain on the motor. Keep away from motor when in operation Periodically check fasteners for tightness, retighten if needed Motor should be removed from bracket when trailering.